Chemical Datasheet
REACTIVE BLUE 19 |
Chemical Identifiers
The
Chemical Identifier fields
include common identification numbers, the
NFPA diamond
U.S. Department of Transportation hazard labels, and a general
description of the chemical. The information in CAMEO Chemicals comes
from a variety of
data sources.
CAS Number | UN/NA Number | DOT Hazard Label | USCG CHRIS Code |
---|---|---|---|
|
none | data unavailable | none |
NIOSH Pocket Guide | International Chem Safety Card | ||
none | none |
NFPA 704
data unavailable
General Description
PHYSICAL DESCRIPTION: Fine blue-black powder. (NTP, 1992)
Hazards
The
Hazard fields
include
special hazard alerts
air and water
reactions, fire hazards, health hazards, a reactivity profile, and
details about
reactive groups assignments
and
potentially incompatible absorbents.
The information in CAMEO Chemicals comes from a variety of
data sources.
Reactivity Alerts
none
Air & Water Reactions
Water soluble.
Fire Hazard
Flash point data for this chemical are not available; however, it is probably combustible. (NTP, 1992)
Health Hazard
ACUTE/CHRONIC HAZARDS: When heated to decomposition this compound emits very toxic fumes of sodium oxide, nitrogen oxides and sulfur oxides. (NTP, 1992)
Reactivity Profile
No information available.
Belongs to the Following Reactive Group(s)
Potentially Incompatible Absorbents
No information available.
Response Recommendations
The
Response Recommendation fields
include isolation and evacuation distances, as well as recommendations for
firefighting, non-fire response, protective clothing, and first aid. The
information in CAMEO Chemicals comes from a variety of
data sources.
Isolation and Evacuation
No information available.
Firefighting
Fires involving this material can be controlled with a dry chemical, carbon dioxide or Halon extinguisher. (NTP, 1992)
Non-Fire Response
SMALL SPILLS AND LEAKAGE: If you spill this chemical, you should dampen the solid spill material with water, then transfer the dampened material to a suitable container. Use absorbent paper dampened with water to pick up any remaining material. Seal your contaminated clothing and the absorbent paper in a vapor-tight plastic bag for eventual disposal. Wash all contaminated surfaces with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned.
STORAGE PRECAUTIONS: You should store this material under ambient temperatures. (NTP, 1992)
STORAGE PRECAUTIONS: You should store this material under ambient temperatures. (NTP, 1992)
Protective Clothing
RECOMMENDED RESPIRATOR: Where the neat test chemical is weighed and diluted, wear a NIOSH-approved half face respirator equipped with an organic vapor/acid gas cartridge (specific for organic vapors, HCl, acid gas and SO2) with a dust/mist filter. (NTP, 1992)
DuPont Tychem® Suit Fabrics
No information available.
First Aid
EYES: First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop.
SKIN: IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. If symptoms such as redness or irritation develop, IMMEDIATELY call a physician and be prepared to transport the victim to a hospital for treatment.
INHALATION: IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used; if not available, use a level of protection greater than or equal to that advised under Protective Clothing.
INGESTION: DO NOT INDUCE VOMITING. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician. If the victim is convulsing or unconscious, do not give anything by mouth, ensure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. IMMEDIATELY transport the victim to a hospital. (NTP, 1992)
SKIN: IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. If symptoms such as redness or irritation develop, IMMEDIATELY call a physician and be prepared to transport the victim to a hospital for treatment.
INHALATION: IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used; if not available, use a level of protection greater than or equal to that advised under Protective Clothing.
INGESTION: DO NOT INDUCE VOMITING. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician. If the victim is convulsing or unconscious, do not give anything by mouth, ensure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. IMMEDIATELY transport the victim to a hospital. (NTP, 1992)
Physical Properties
The
Physical Property fields
include properties such as vapor pressure and
boiling point, as well as explosive limits and
toxic exposure thresholds
The information in CAMEO Chemicals comes from a variety of
data sources.
Note: For Vapor Density and Specific Gravity, comparing the value to 1.0 can tell you if the chemical will likely sink/rise in air or sink/float in fresh water (respectively). Short phrases have been added to those values below as an aid. However, make sure to also consider the circumstances of a release. The Vapor Density comparisons are only valid when the gas escaping is at the same temperature as the surrounding air itself. If the chemical is escaping from a container where it was pressurized or refrigerated, it may first escape and behave as a heavy gas and sink in the air (even if it has a Vapor Density value less than 1). Also, the Specific Gravity comparisons are for fresh water (density 1.0 g/mL). If your spill is in salt water (density about 1.027 g/mL), you need to adjust the point of comparison. There are some chemicals that will sink in fresh water and float in salt water.
Note: For Vapor Density and Specific Gravity, comparing the value to 1.0 can tell you if the chemical will likely sink/rise in air or sink/float in fresh water (respectively). Short phrases have been added to those values below as an aid. However, make sure to also consider the circumstances of a release. The Vapor Density comparisons are only valid when the gas escaping is at the same temperature as the surrounding air itself. If the chemical is escaping from a container where it was pressurized or refrigerated, it may first escape and behave as a heavy gas and sink in the air (even if it has a Vapor Density value less than 1). Also, the Specific Gravity comparisons are for fresh water (density 1.0 g/mL). If your spill is in salt water (density about 1.027 g/mL), you need to adjust the point of comparison. There are some chemicals that will sink in fresh water and float in salt water.
Chemical Formula: |
|
Flash Point: data unavailable
Lower Explosive Limit (LEL): data unavailable
Upper Explosive Limit (UEL): data unavailable
Autoignition Temperature: data unavailable
Melting Point:
Decomposes at approximately 581°F
(NTP, 1992)
Vapor Pressure: data unavailable
Vapor Density (Relative to Air): data unavailable
Specific Gravity: data unavailable
Boiling Point: data unavailable
Molecular Weight:
626.56
(NTP, 1992)
Water Solubility:
10 to 50 mg/mL
at 70°F
(NTP, 1992)
Ionization Energy/Potential: data unavailable
IDLH: data unavailable
AEGLs (Acute Exposure Guideline Levels)
No AEGL information available.ERPGs (Emergency Response Planning Guidelines)
No ERPG information available.PACs (Protective Action Criteria)
No PAC information available.Regulatory Information
The
Regulatory Information fields
include information from
the U.S. Environmental Protection Agency's Title III Consolidated List of
Lists,
the U.S. Cybersecurity and Infrastructure Security Agency's Chemical Facility
Anti-Terrorism Standards,
and the U.S. Occupational Safety and Health Administration's
Process Safety Management of Highly Hazardous Chemicals Standard List
(see more about these
data sources).
EPA Consolidated List of Lists
No regulatory information available.CISA Chemical Facility Anti-Terrorism Standards (CFATS)
No regulatory information available.OSHA Process Safety Management (PSM) Standard List
No regulatory information available.Alternate Chemical Names
This section provides a listing of alternate names for this chemical,
including trade names and synonyms.
- 1-AMINO-4-[3-(BETA-SULFATOETHYLSULFONYL)ANILINO]-2-ANTHRAQUINONESULFONIC ACID DISODIUM SALT
- 1-AMINO-9,10-DIHYDRO-4-(M-((2-HYDROXYETHYL)SULFONYL)ANILINO)-9,10-DIOXO-2-ANTHRACENESULFONIC ACID, HYDROGEN SULFATE (ESTER), DISODIUM SALT
- 1-AMINO-9,10-DIHYDRO-9,10-DIOXO-4((3-((2-(SULFOOXY)ETHYL)SULFONYL)PHENYL)-AMINO)-2-ANTHRACENESULFONIC ACID, DISODIUM SALT
- 2-ANTHRACENESULFONIC ACID, 1-AMINO-9,10-DIHYDRO-4-(M-((2-HYDROXYETHYL)-SULFONYL)ANILINO)-9,10-DIOXO-, HYDROGEN SULFATE (ESTER), DISODIUM SALT
- 2-ANTHRACENESULFONIC ACID, 1-AMINO-9,10-DIHYDRO-4-[M-[(2-HYDROXYETHYL)SULFONYL]ANILINO]-9,10-DIOXO-, HYDROGEN SULFATE (ESTER), DISODIUM SALT
- 2-ANTHRACENESULFONIC ACID, 1-AMINO-9,10-DIHYDRO-4-[M-[(2-HYDROXYETHYL)SULFONYL]ANILINO]-9,10-DIOXO-, HYDROGEN SULFATE, DISODIUM SALT
- 2-ANTHRACENESULFONIC ACID, 1-AMINO-9,10-DIHYDRO-9,10-DIOXO-4-((3-((2-(SULFOOXY)ETHYL)SULFONYL)PHENYL)AMINO)-, DISODIUM SALT
- 2-ANTHRAQUINONESULFONIC ACID, 1-AMINO-4-[M-(2-HYDROXYETHYLSULFONYL)ANILINO]-, HYDROGEN SULFATE DISODIUM SALT
- BRILLIANT BLUE R
- C.I. 61200
- C.I. REACTIVE BLUE 19
- C.I. REACTIVE BLUE 19, DISODIUM SALT
- CAVALITE BRILLIANT BLUE R
- CELMAZOL BRILLIANT BLUE R
- DIAMIRA BRILLIANT BLUE R
- DIAMIRA BRILLIANT BLUE R-KN
- EVERFIX BRILLIANT BLUE R
- INTRACRON BRILLIANT BLUE VS-R
- OSTAZIN BRILLIANT BLUE UR
- OSTAZIN BRILLIANT BLUE VR
- PRIMAZIN BRILLIANT BLUE RL
- REACTIVE BLUE 19
- REMALAN BRILLIANT BLUE R
- REMAZOL BLUE R
- REMAZOL BRILLIANT BLUE R
- REMAZOL BRILLIANT BLUE R SPEC
- REMAZOL BRILLIANT BLUE R SPECIAL
- REMAZOL BRILLIANT BLUE R-KN
- REMAZOL BRILLIANT BLUE R-KN LIQ 40
- REMAZOL BRILLIANT BLUE RN
- SUMIFIX BRILLIANT BLUE R
- SUMIFIX BRILLIANT BLUE R SPECIAL
- SUMIFIX BRILLIANT BLUE R SPECIAL LIQIUD
- SUMIFIX BRILLIANT BLUE R(B)