Chemical Datasheet
DIRECT BLUE 1 |
Chemical Identifiers
The
Chemical Identifier fields
include common identification numbers, the
NFPA diamond
U.S. Department of Transportation hazard labels, and a general
description of the chemical. The information in CAMEO Chemicals comes
from a variety of
data sources.
CAS Number | UN/NA Number | DOT Hazard Label | USCG CHRIS Code |
---|---|---|---|
|
none | data unavailable | none |
NIOSH Pocket Guide | International Chem Safety Card | ||
none | none |
NFPA 704
data unavailable
General Description
PHYSICAL DESCRIPTION: Bright greenish-blue solid or dark blue powder. (NTP, 1992)
Hazards
The
Hazard fields
include
special hazard alerts
air and water
reactions, fire hazards, health hazards, a reactivity profile, and
details about
reactive groups assignments
and
potentially incompatible absorbents.
The information in CAMEO Chemicals comes from a variety of
data sources.
Reactivity Alerts
- Explosive
Air & Water Reactions
Azo dyes can be explosive when suspended in air at specific concentrations. Slightly soluble in water.
Fire Hazard
Flash point data for this chemical are not available; however, it is probably combustible. (NTP, 1992)
Health Hazard
SYMPTOMS: Symptoms of exposure to this compound include skin sensitization, headache, dizziness, low blood pressure, lethargy, painful urination, anemia, jaundice, convulsions, coma and possible death.
ACUTE/CHRONIC HAZARDS: This compound may be harmful by inhalation, skin contact or ingestion. When heated to decomposition it emits toxic fumes. (NTP, 1992)
ACUTE/CHRONIC HAZARDS: This compound may be harmful by inhalation, skin contact or ingestion. When heated to decomposition it emits toxic fumes. (NTP, 1992)
Reactivity Profile
DIRECT BLUE 1 is an azo compound. Azo, diazo, azido compounds can detonate. This applies in particular to organic azides that have been sensitized by the addition of metal salts or strong acids. Toxic gases are formed by mixing materials of this class with acids, aldehydes, amides, carbamates, cyanides, inorganic fluorides, halogenated organics, isocyanates, ketones, metals, nitrides, peroxides, phenols, epoxides, acyl halides, and strong oxidizing or reducing agents. Flammable gases are formed by mixing materials in this group with alkali metals. Explosive combination can occur with strong oxidizing agents, metal salts, peroxides, and sulfides. Cleavage of the diazo group by reducing agents may lead to benzidine production. (NTP, 1992)
Belongs to the Following Reactive Group(s)
Potentially Incompatible Absorbents
No information available.
Response Recommendations
The
Response Recommendation fields
include isolation and evacuation distances, as well as recommendations for
firefighting, non-fire response, protective clothing, and first aid. The
information in CAMEO Chemicals comes from a variety of
data sources.
Isolation and Evacuation
No information available.
Firefighting
Fires involving this material can be controlled using a dry chemical, carbon dioxide or Halon extinguisher. (NTP, 1992)
Non-Fire Response
SMALL SPILLS AND LEAKAGE: If you spill this chemical, you should dampen the solid spill material with water, then transfer the dampened material to a suitable container. Use absorbent paper dampened with water to pick up any remaining material. Seal your contaminated clothing and the absorbent paper in a vapor-tight plastic bag for eventual disposal. Wash all contaminated surfaces with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned.
STORAGE PRECAUTIONS: You should store this material in a refrigerator. (NTP, 1992)
STORAGE PRECAUTIONS: You should store this material in a refrigerator. (NTP, 1992)
Protective Clothing
RECOMMENDED RESPIRATOR: Where the neat test chemical is weighed and diluted, wear a NIOSH-approved half face respirator equipped with an organic vapor/acid gas cartridge (specific for organic vapors, HCl, acid gas and SO2) with a dust/mist filter. (NTP, 1992)
DuPont Tychem® Suit Fabrics
No information available.
First Aid
EYES: First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop.
SKIN: IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. If symptoms such as redness or irritation develop, IMMEDIATELY call a physician and be prepared to transport the victim to a hospital for treatment.
INHALATION: IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used; if not available, use a level of protection greater than or equal to that advised under Protective Clothing.
INGESTION: DO NOT INDUCE VOMITING. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician. If the victim is convulsing or unconscious, do not give anything by mouth, ensure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. IMMEDIATELY transport the victim to a hospital. (NTP, 1992)
SKIN: IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. If symptoms such as redness or irritation develop, IMMEDIATELY call a physician and be prepared to transport the victim to a hospital for treatment.
INHALATION: IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used; if not available, use a level of protection greater than or equal to that advised under Protective Clothing.
INGESTION: DO NOT INDUCE VOMITING. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician. If the victim is convulsing or unconscious, do not give anything by mouth, ensure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. IMMEDIATELY transport the victim to a hospital. (NTP, 1992)
Physical Properties
The
Physical Property fields
include properties such as vapor pressure and
boiling point, as well as explosive limits and
toxic exposure thresholds
The information in CAMEO Chemicals comes from a variety of
data sources.
Note: For Vapor Density and Specific Gravity, comparing the value to 1.0 can tell you if the chemical will likely sink/rise in air or sink/float in fresh water (respectively). Short phrases have been added to those values below as an aid. However, make sure to also consider the circumstances of a release. The Vapor Density comparisons are only valid when the gas escaping is at the same temperature as the surrounding air itself. If the chemical is escaping from a container where it was pressurized or refrigerated, it may first escape and behave as a heavy gas and sink in the air (even if it has a Vapor Density value less than 1). Also, the Specific Gravity comparisons are for fresh water (density 1.0 g/mL). If your spill is in salt water (density about 1.027 g/mL), you need to adjust the point of comparison. There are some chemicals that will sink in fresh water and float in salt water.
Note: For Vapor Density and Specific Gravity, comparing the value to 1.0 can tell you if the chemical will likely sink/rise in air or sink/float in fresh water (respectively). Short phrases have been added to those values below as an aid. However, make sure to also consider the circumstances of a release. The Vapor Density comparisons are only valid when the gas escaping is at the same temperature as the surrounding air itself. If the chemical is escaping from a container where it was pressurized or refrigerated, it may first escape and behave as a heavy gas and sink in the air (even if it has a Vapor Density value less than 1). Also, the Specific Gravity comparisons are for fresh water (density 1.0 g/mL). If your spill is in salt water (density about 1.027 g/mL), you need to adjust the point of comparison. There are some chemicals that will sink in fresh water and float in salt water.
Chemical Formula: |
|
Flash Point: data unavailable
Lower Explosive Limit (LEL): data unavailable
Upper Explosive Limit (UEL): data unavailable
Autoignition Temperature: data unavailable
Melting Point: data unavailable
Vapor Pressure: data unavailable
Vapor Density (Relative to Air): data unavailable
Specific Gravity: data unavailable
Boiling Point: data unavailable
Molecular Weight:
992.81
(NTP, 1992)
Water Solubility:
1 to 5 mg/mL
at 73°F
(NTP, 1992)
Ionization Energy/Potential: data unavailable
IDLH: data unavailable
AEGLs (Acute Exposure Guideline Levels)
No AEGL information available.ERPGs (Emergency Response Planning Guidelines)
No ERPG information available.PACs (Protective Action Criteria)
No PAC information available.Regulatory Information
The
Regulatory Information fields
include information from
the U.S. Environmental Protection Agency's Title III Consolidated List of
Lists,
the U.S. Cybersecurity and Infrastructure Security Agency's Chemical Facility
Anti-Terrorism Standards,
and the U.S. Occupational Safety and Health Administration's
Process Safety Management of Highly Hazardous Chemicals Standard List
(see more about these
data sources).
EPA Consolidated List of Lists
No regulatory information available.CISA Chemical Facility Anti-Terrorism Standards (CFATS)
No regulatory information available.OSHA Process Safety Management (PSM) Standard List
No regulatory information available.Alternate Chemical Names
This section provides a listing of alternate names for this chemical,
including trade names and synonyms.
- AIREDALE BLUE FFD
- AMANIL SKY BLUE 6B
- AMANIL SKY BLUE FF
- ATLANTIC RESIN FAST BLUE
- ATLANTIC RESIN FAST BLUE LLGG
- ATLANTIC SKY BLUE 6B
- ATLANTIC SKY BLUE FF
- ATUL DIRECT SKY BLUE FB
- AZINE BRILLIANT BLUE 6B
- AZOCARD BLUE 6B
- BELAMINE SKY BLUE FF
- BENZANIL SKY BLUE FF
- BENZO BRILLIANT BLUE 6BS
- BLUE 6B
- BRASILAMINA SKY BLUE 6B
- BRILLIANT BENZO BLUE
- BRILLIANT BENZO BLUE 6BA-CF
- BRILLIANT BLUE 6B
- C.I. 24410
- C.I. DIRECT BLUE 1
- C.I. DIRECT BLUE 1, TETRASODIUM SALT
- CALCODUR BLUE 6GFL
- CALCODUR RESIN FAST BLUE 6G
- CALCOMINE SKY BLUE FF
- CHICAGO BLUE
- CHICAGO BLUE 6B
- CHICAGO SKY BLUE
- CHICAGO SKY BLUE 6B
- CHLORAMINE SKY BLUE FF
- CHLORANTINE FAST BLUE B 5GL
- CHLORAZOL SKY BLUE FF
- CHROME LEATHER SKY BLUE
- CHROME LEATHER SKY BLUE GS
- CRESOTINE BLUE 6B
- DIACOTTON SKY BLUE 6B
- DIAPHTAMINE BLUE BS
- DIAZINE SKY BLUE FF
- DIAZOL PURE BLUE 6B
- 3,3'-(3,3'-DIMETHOXY-4,4'-BIPHENYLENE)BIS(AZO)BIS(5-AMINO-4-HYDROXY-6,8-NAPHTHALENEDISULFONIC ACID, TETRASODIUM SALT
- DIPHENYL BRILLIANT BLUE FF
- DIRECT AZURE BLUE 6B
- DIRECT BLUE 1
- DIRECT BLUE 6B
- DIRECT BLUE 6BS
- DIRECT BLUE FF
- DIRECT BLUE FFN
- DIRECT BRIGHT BLUE
- DIRECT BRILLIANT BLUE FF
- DIRECT BRILLIANT BLUE MFF
- DIRECT BRILLIANT SKY BLUE 6B
- DIRECT PURE BLUE 6B
- DIRECT PURE BLUE FF
- DIRECT PURE SKY BLUE
- DIRECT SKY 6B
- DIRECT SKY BLUE 6B
- DIRECT SKY BLUE 6BS
- DIRECT SKY BLUE 6D
- DIRECT SKY BLUE FF
- DIRECT SKY BLUE GREEN SHADE
- DIRECT SKY BLUE GS
- ENIANIL BRILLIANT BLUE FF
- FASTUSOL BRILLIANT BLUE L 8GU
- FENAMIN BRILLIANT BLUE 6BKX
- FENAMIN SKY BLUE 3F
- FIXANOL SKY BLUE FF
- HISPAMIN SKY BLUE 6B
- INCOMINE SKY BLUE 6B
- INK BLUE 6B
- JAPANOL BRILLIANT BLUE 6BKX
- KAYAKU DIRECT SKY BLUE 6B
- MITSUI DIRECT BRILLIANT BLUE 6B
- NAPHTAMINE SKY BLUE DD
- 1,3-NAPHTHALENE-DISULFONIC ACID,6,6'-((3,3'-DIMETHOXY(1,1'-BIPHENYL-4,4'-DIYL)BIS-AZO))BIS(4-AMINO-5-HYDROXY-),TETRASODIUM SALT
- NIAGARA BLUE 6B
- NIAGARA SKY BLUE 6B
- NIAGRA SKY BLUE DD
- NYANZA SKY BLUE 6B
- ORBAMIN BRILLIANT BLUE FF
- OXAMINE SKY BLUE 6B
- PAPER BLUE 6B
- PARAMINE SKY BLUE FF
- PHENAMINE BRILLIANT BLUE 6B
- PHENO SKY BLUE 6BX
- PONTAMINE SKY BLUE
- PONTAMINE SKY BLUE 6BX
- PONTAMINE SKY BLUE 6BX GREENISH
- PURE BLUE
- PURE SKY BLUE 6B
- PYRAZOL BLUE 2F
- PYRAZOL FAST BRILLIANT BLUE VP
- SHIKISO DIRECT SKY BLUE 6B
- SIRIUS SUPRA BLUE 4G
- SKY BLUE 6B
- SKY BLUE FF
- SOLAR BLUE 4GL
- TERTRODIRECT BLUE FF
- VEGENTINE BLUE CSW
- VONDACEL BLUE FF