Add to MyChemicals Print Friendly Page
Chemical Datasheet

MOTOR FUEL ANTI-KNOCK COMPOUNDS. [CONTAINING LEAD ALKYLS]

6.1 - Poison 3 - Flammable liquid
Chemical Identifiers | Hazards | Response Recommendations | Physical Properties | Regulatory Information | Alternate Chemical Names

Chemical Identifiers

The Chemical Identifier fields include common identification numbers, the NFPA diamond, U.S. Department of Transportation hazard labels, and a general description of the chemical. The information in CAMEO Chemicals comes from a variety of data sources..
CAS Number UN/NA Number DOT Hazard Label USCG CHRIS Code
none
  • Poison
  • Flammable Liquid
NFPA 704
data unavailable
NIOSH Pocket Guide International Chem Safety Card
none none
General Description
Oily liquids, dyed red, orange or blue, with sweet fruity odors. Denser than water and insoluble in water. Hence sink in water. (USCG, 1999)

Hazards

The Hazard fields include special hazard alerts, air and water reactions, fire hazards, health hazards, a reactivity profile, and details about reactive groups assignments and potentially incompatible absorbents. The information in CAMEO Chemicals comes from a variety of data sources.
Reactivity Alerts
Air & Water Reactions
Highly flammable. Insoluble in water.
Fire Hazard
Special Hazards of Combustion Products: Toxic lead-containing gases are generated in fires.

Behavior in Fire: Containers may explode (USCG, 1999)
Health Hazard
Increased urinary output of lead. Large degree of absorption from inhalation or skin contact may cause insomnia, excitability, delirium, coma and death. (USCG, 1999)
Reactivity Profile
LEAD ALKYLS reacts with oxidizing materials, active metals and rust in reactions that are not considered hazardous (USCG, 1999).
Belongs to the Following Reactive Group(s)
Potentially Incompatible Absorbents

No information available.

Response Recommendations

The Response Recommendation fields include isolation and evacuation distances, as well as recommendations for firefighting, non-fire response, protective clothing, and first aid. The information in CAMEO Chemicals comes from a variety of data sources.
Isolation and Evacuation
Excerpt from ERG Guide 131 [Flammable Liquids - Toxic]:

As an immediate precautionary measure, isolate spill or leak area for at least 50 meters (150 feet) in all directions.

SPILL: Increase, in the downwind direction, as necessary, the isolation distance shown above.

FIRE: If tank, rail car or tank truck is involved in a fire, ISOLATE for 800 meters (1/2 mile) in all directions; also, consider initial evacuation for 800 meters (1/2 mile) in all directions. (ERG, 2016)
Firefighting
Fire Extinguishing Agents: Water, foam, dry chemical, carbon dioxide (USCG, 1999)
Non-Fire Response
Excerpt from ERG Guide 131 [Flammable Liquids - Toxic]:

Fully encapsulating, vapor-protective clothing should be worn for spills and leaks with no fire. ELIMINATE all ignition sources (no smoking, flares, sparks or flames in immediate area). All equipment used when handling the product must be grounded. Do not touch or walk through spilled material. Stop leak if you can do it without risk. Prevent entry into waterways, sewers, basements or confined areas. A vapor-suppressing foam may be used to reduce vapors.

SMALL SPILL: Absorb with earth, sand or other non-combustible material and transfer to containers for later disposal. Use clean, non-sparking tools to collect absorbed material.

LARGE SPILL: Dike far ahead of liquid spill for later disposal. Water spray may reduce vapor, but may not prevent ignition in closed spaces. (ERG, 2016)
Protective Clothing
Organic vapor cartridge-type face mask for emergency or short duration; fresh air mask for longer duration; impervious protective gloves; goggles as required; boots and light-colored clothing. (USCG, 1999)
DuPont Tychem® Suit Fabrics
No information available.
First Aid
Call a physician for any exposure.

INHALATION: remove from exposure.

INGESTION: no specific antidote.

EYES: flush with plenty of water for about 15 min.

SKIN: flush with kerosine, wash with soap and water. (USCG, 1999)

Physical Properties

The Physical Property fields include properties such as vapor pressure and boiling point, as well as explosive limits and toxic exposure thresholds. The information in CAMEO Chemicals comes from a variety of data sources.
Chemical Formula: data unavailable
Flash Point: 89 to 265 ° F (USCG, 1999)
Lower Explosive Limit (LEL): data unavailable
Upper Explosive Limit (UEL): data unavailable
Autoignition Temperature: 212 ° F (USCG, 1999)
Melting Point: data unavailable
Vapor Pressure: 87.89 mm Hg (USCG, 1999)
Vapor Density (Relative to Air): data unavailable
Specific Gravity: 1.5 to 1.7 at 59 ° F (USCG, 1999)
Boiling Point: greater than 200 ° F at 760 mm Hg (USCG, 1999)
Molecular Weight: data unavailable
Water Solubility: data unavailable
Ionization Potential: data unavailable
IDLH: data unavailable

AEGLs (Acute Exposure Guideline Levels)

No AEGL information available.

ERPGs (Emergency Response Planning Guidelines)

No ERPG information available.

PACs (Protective Action Criteria)

No PAC information available.

Regulatory Information

The Regulatory Information fields include information from the U.S. Environmental Protection Agency's Title III Consolidated List of Lists and the U.S. Department of Homeland Security's Chemical Facility Anti-Terrorism Standards (see more about these data sources).

EPA Consolidated List of Lists

Regulatory Name CAS Number/
313 Category Code
EPCRA 302
EHS TPQ
EPCRA 304
EHS RQ
CERCLA RQ EPCRA 313
TRI
RCRA
Code
CAA 112(r)
RMP TQ
Lead Compounds N420 & 313

(EPA List of Lists, 2015)

DHS Chemical Facility Anti-Terrorism Standards (CFATS)

No regulatory information available.

Alternate Chemical Names

This section provides a listing of alternate names for this chemical, including trade names and synonyms.