Print
Chemical Datasheet

HYDROGEN PEROXIDE, STABILIZED

5.1 - Oxidizer 8 - Corrosive

Chemical Identifiers

CAS Number UN/NA Number DOT Hazard Label USCG CHRIS Code
  • 7722-84-1   (HYDROGEN PEROXIDE)
  • 2015
  • Oxidizer
  • Corrosive
  • HPO
NIOSH Pocket Guide International Chem Safety Card
Hydrogen peroxide
  • HYDROGEN PEROXIDE (>60% SOLUTION IN WATER)
NFPA 704
Diamond Hazard Value Description
0
3 3
ox
Blue Health 3 Can cause serious or permanent injury.
Red Flammability 0 Will not burn under typical fire conditions.
Yellow Instability 3 Capable of detonation or explosive decomposition or explosive reaction but requires a strong initiating source or must be heated under confinement before initiation.
White Special OX Possesses oxidizing properties.
(NFPA, 2010)
General Description
A crystalline solid at low temperatures. Has a slightly pungent, irritating odor. Used in the bleaching and deodorizing of textiles, wood pulp, hair, fur, etc. as a source of organic and inorganic peroxides; pulp and paper industry; plasticizers; rocket fuel; foam rubber; manufacture of glycerol; antichlor; dyeing; electroplating; antiseptic; laboratory reagent; epoxidation; hydroxylation; oxidation and reduction; viscosity control for starch and cellulose derivatives; refining and cleaning metals; bleaching and oxidizing agent in foods; neutralizing agent in wine distillation; seed disinfectant; substitute for chlorine in water and sewage treatment. (EPA, 1998)

Hazards

Reactivity Alerts
Air & Water Reactions
Water soluble.
Fire Hazard
Spontaneous ignition may occur when contact with combustible materials is made. Oxygen released in decomposition will promote combustion. Fires can be of the flaring type but are not explosive unless confined. Vapor concentration greater than 40 percent by weight can be decomposed explosively at 1 atmosphere pressure. Severe explosion hazard when it is exposed to heat, mechanical impact, detonation of a blasting cap, or caused to decompose catalytically. Decomposition can build up large pressures of oxygen and water which may then burst explosively. Avoid oxidizable materials including iron, copper, brass, bronze, chromium, zinc, lead, manganese, silver, catalytic metals. Avoid mechanical impact, uncovering the container, contact with combustible materials, light, temperatures above 95F, hot wires, catalytic impurities. (EPA, 1998)
Health Hazard
Strong irritant to skin, eyes, and mucous membranes. (EPA, 1998)
Reactivity Profile
The hazards associated with the use of HYDROGEN PEROXIDE (especially highly concentrated solutions) are well documented. There is a release of enough energy during the catalytic decomposition of 65% peroxide to evaporate all water and ignite nearby combustible materials. Most cellulose materials contain enough catalyst to cause spontaneous ignition with 90% peroxide. Contamination of concentrated peroxide causes the possibility of explosion. Readily oxidizable materials, or alkaline substances containing heavy metals may react violently. Solvents(acetone, ethanol, glycerol) will detonate on mixture with peroxide of over 30% concentration, the violence increasing with concentration. Concentrated peroxide may decompose violently in contact with iron, copper, chromium, and most other metals or their salts, and dust(which frequently contain rust). During concentration under vacuum of aqueous or of aqueous-alcoholic solutions of hydrogen peroxide, violent explosions occurred when the concentration was sufficiently high(>90%), [Bretherick 2nd ed., 1979]. Mixtures of alcohols with concentrated sulfuric acid and strong hydrogen peroxide can cause explosions. Example: An explosion will occur if dimethylbenzylcarbinol is added to 90% hydrogen peroxide then acidified with concentrated sulfuric acid. Mixtures of ethyl alcohol with concentrated hydrogen peroxide form powerful explosives. Mixtures of hydrogen peroxide and 1-phenyl-2-methyl propyl alcohol tend to explode if acidified with 70% sulfuric acid, [Chem. Eng. News 45(43):73(1967); J, Org. Chem. 28:1893(1963)]. Hydrogen selenide and hydrogen peroxide undergo a very rapid decomposition, [Mellor 1:941(1946-1947)].
Belongs to the Following Reactive Group(s)
Potentially Incompatible Absorbents

Use caution: Liquids with this reactive group classification have been known to react with the absorbents listed below.

Response Recommendations

Isolation and Evacuation
Excerpt from ERG Guide 143 [Oxidizers (Unstable)]:

IMMEDIATE PRECAUTIONARY MEASURE: Isolate spill or leak area in all directions for at least 50 meters (150 feet) for liquids and at least 25 meters (75 feet) for solids.

SPILL: Increase the immediate precautionary measure distance, in the downwind direction, as necessary.

FIRE: If tank, rail tank car or highway tank is involved in a fire, ISOLATE for 800 meters (1/2 mile) in all directions; also, consider initial evacuation for 800 meters (1/2 mile) in all directions. (ERG, 2024)
Firefighting
Keep unnecessary people away; isolate hazard area and deny entry. Stay upwind; keep out of low areas. Wear self-contained (positive pressure if available) breathing apparatus and full protective clothing. Move container from fire area if you can do it without risk. Cool containers that are exposed to flames with water from the side until well after fire is out. For massive fire in cargo area, use unamnned hose holder or monitor nozzles; if this is impossible, withdraw from area and let fire burn.

Not flammable. Fires should be fought with water since the use of chemical extinguishants may accelerate decomposition. Small fires: water only; no dry chemical or carbon dioxide. Large fires: flood fire area with water. (EPA, 1998)
Non-Fire Response
Caution : Explosion potential is high. Hydrogen peroxide may ignite combustable materials.

Keep unnecessary people away; isolate hazard area and deny entry. Stay upwind; keep out of low areas. Keep combustibles (wood, paper, oil, etc.) away from spilled material. Do not touch spilled material; stop leak if you can do it without risk. Use water spray to reduce vapors; do not get water inside container.

Small dry spills: with clean shovel place material into clean, dry container and cover; move containers from spill area.

Small spills: flush area with flooding amounts of water.

Large spills: dike far ahead of spill for later disposal. (EPA, 1998)
Protective Clothing
Excerpt from NIOSH Pocket Guide for Hydrogen peroxide:

Skin: PREVENT SKIN CONTACT - Wear appropriate personal protective clothing to prevent skin contact.

Eyes: PREVENT EYE CONTACT - Wear appropriate eye protection to prevent eye contact.

Wash skin: WHEN CONTAMINATED - The worker should immediately wash the skin when it becomes contaminated.

Remove: WHEN WET OR CONTAMINATED - Work clothing that becomes wet or significantly contaminated should be removed and replaced.

Change: No recommendation is made specifying the need for the worker to change clothing after the workshift.

Provide:
• EYEWASH - Eyewash fountains should be provided in areas where there is any possibility that workers could be exposed to the substances; this is irrespective of the recommendation involving the wearing of eye protection.
• QUICK DRENCH - Facilities for quickly drenching the body should be provided within the immediate work area for emergency use where there is a possibility of exposure. [Note: It is intended that these facilities provide a sufficient quantity or flow of water to quickly remove the substance from any body areas likely to be exposed. The actual determination of what constitutes an adequate quick drench facility depends on the specific circumstances. In certain instances, a deluge shower should be readily available, whereas in others, the availability of water from a sink or hose could be considered adequate.] (NIOSH, 2024)
DuPont Tychem® Suit Fabrics
Normalized Breakthrough Times (in Minutes)
Chemical CAS Number State QS QC SL C3 TF TP RC TK RF
Hydrogen peroxide (30%) 7722-84-1 Liquid >480 >480 >480 >480
Hydrogen peroxide (50%) 7722-84-1 Liquid >480 >480 >480 >480
Hydrogen peroxide (70%) 7722-84-1 Liquid >480 >480 >480 >480 >480 >480 >480
> indicates greater than.

Special Warning from DuPont: Tychem® and Tyvek® fabrics should not be used around heat, flames, sparks or in potentially flammable or explosive environments. Only...

(DuPont, 2024)

First Aid
Signs and Symptoms of Acute Hydrogen Peroxide Exposure: Signs and symptoms of acute exposure to hydrogen peroxide may be severe and include irritation or burns to the skin, eyes, respiratory tract, mouth, esophagus, stomach, and intestines. Distension or rupture of the stomach and other hollow viscera may occur; vomiting is common. Corneal ulceration may develop.

Emergency Life-Support Procedures: Acute exposure to hydrogen peroxide may require decontamination and life support for the victims. Emergency personnel should wear protective clothing appropriate to the type and degree of contamination. Air-purifying or supplied-air respiratory equipment should also be worn, as necessary. Rescue vehicles should carry supplies such as plastic sheeting and disposable plastic bags to assist in preventing spread of contamination.

Inhalation Exposure:
1. Move victims to fresh air. Emergency personnel should avoid self-exposure to hydrogen peroxide.
2. Evaluate vital signs including pulse and respiratory rate, and note any trauma. If no pulse is detected, provide CPR. If not breathing, provide artificial respiration. If breathing is labored, administer oxygen or other respiratory support.
3. Obtain authorization and/or further instructions from the local hospital for administration of an antidote or performance of other invasive procedures.
4. Transport to a health care facility.

Dermal/Eye Exposure:
1. Remove victims from exposure. Emergency personnel should avoid self- exposure to hydrogen peroxide.
2. Evaluate vital signs including pulse and respiratory rate, and note any trauma. If no pulse is detected, provide CPR. If not breathing, provide artificial respiration. If breathing is labored, administer oxygen or other respiratory support.
3. Remove contaminated clothing as soon as possible.
4. If eye exposure has occurred, eyes must be flushed with lukewarm water for at least 15 minutes.
5. Wash exposed skin areas THOROUGHLY with soap and water.
6. Obtain authorization and/or further instructions from the local hospital for administration of an antidote or performance of other invasive procedures.
7. Transport to a health care facility.

Ingestion Exposure:
1. Evaluate vital signs including pulse and respiratory rate, and note any trauma. If no pulse is detected, provide CPR. If not breathing, provide artificial respiration. If breathing is labored, administer oxygen or other respiratory support.
2. DO NOT induce vomiting or attempt to neutralize!
3. Obtain authorization and/or further instructions from the local hospital for administration of an antidote or performance of other invasive procedures.
4. Activated charcoal is of no value.
5. Give the victims water or milk: children up to 1 year old, 125 mL (4 oz or 1/2 cup); children 1 to 12 years old, 200 mL (6 oz or 3/4 cup); adults, 250 mL (8 oz or 1 cup). Water or milk should be given only if victims are conscious and alert.
6. Transport to a health care facility. (EPA, 1998)

Physical Properties

Chemical Formula:
  • H2O2
Flash Point: data unavailable
Lower Explosive Limit (LEL): data unavailable
Upper Explosive Limit (UEL): data unavailable
Autoignition Temperature: Not flammable. (USCG, 1999)
Melting Point: 31 to 40°F for concentrations greater than 52% (EPA, 1998)
Vapor Pressure: 1 mmHg at 59.54°F (EPA, 1998)
Vapor Density (Relative to Air): 1.02 calculated (EPA, 1998) - Heavier than air; will sink
Specific Gravity: 1.463 at 32°F 1.29/1.3 at 68F for concentrations greater than 52% (EPA, 1998) - Denser than water; will sink
Boiling Point: 306°F at 760 mmHg ; 258°F for concentrations greater than 52% (EPA, 1998)
Molecular Weight: 34.02 (EPA, 1998)
Water Solubility: Miscible (NIOSH, 2024)
Ionization Energy/Potential: 10.54 eV (NIOSH, 2024)
IDLH: 75 ppm (NIOSH, 2024)

AEGLs (Acute Exposure Guideline Levels)

No AEGL information available.

ERPGs (Emergency Response Planning Guidelines)

Chemical ERPG-1 ERPG-2 ERPG-3
Hydrogen Peroxide (7722-84-1) 10 ppm 50 ppm 100 ppm
(AIHA, 2022)

PACs (Protective Action Criteria)

Chemical PAC-1 PAC-2 PAC-3
Hydrogen peroxide (7722-84-1) 10 ppm 50 ppm 100 ppm
(DOE, 2024)

Regulatory Information

EPA Consolidated List of Lists

Regulatory Name CAS Number/
313 Category Code
EPCRA 302
EHS TPQ
EPCRA 304
EHS RQ
CERCLA RQ EPCRA 313
TRI
RCRA
Code
CAA 112(r)
RMP TQ
Hydrogen peroxide (Conc.> 52%) 7722-84-1 1000 pounds 1000 pounds

(EPA List of Lists, 2024)

CISA Chemical Facility Anti-Terrorism Standards (CFATS)

RELEASE THEFT SABOTAGE
Chemical of Interest CAS Number Min Conc STQ Security
Issue
Min Conc STQ Security
Issue
Min Conc STQ Security
Issue
Hydrogen peroxide (concentration of at least 35%) 7722-84-1 35.00 % 400 pounds EXP/IEDP

(CISA, 2007)

OSHA Process Safety Management (PSM) Standard List

Chemical Name CAS Number Threshold Quantity (TQ)
Hydrogen Peroxide (52% by weight or greater) 7722-84-1 7500 pounds

(OSHA, 2019)

Alternate Chemical Names