ETHYLENE GLYCOL MONOBUTYL ETHER

Diamond	Hazard	Value	Description
2 3 0	Health	3	Can cause serious or permanent injury.
	Flammability	2	Must be moderately heated or exposed to relatively high ambient temperatures before ignition can occur.
	Instability	0	Normally stable, even under fire conditions.
	Special

A colorless liquid with a mild, pleasant odor. Less dense than water. Flash point 160°F. Irritates skin and eyes and may be toxic by ingestion. Used as a solvent and to make paints and varnish.

none

This chemical is sensitive to air and light. Slightly soluble in water.

Excerpt from 128 [Flammable Liquids (Water-Immiscible)]:

HIGHLY FLAMMABLE: Will be easily ignited by heat, sparks or flames. Vapors may form explosive mixtures with air. Vapors may travel to source of ignition and flash back. Most vapors are heavier than air. They will spread along the ground and collect in low or confined areas (sewers, basements, tanks, etc.). Vapor explosion hazard indoors, outdoors or in sewers. Those substances designated with a (P) may polymerize explosively when heated or involved in a fire. Runoff to sewer may create fire or explosion hazard. Containers may explode when heated. Many liquids will float on water. Substance may be transported hot. For hybrid vehicles, 147 (lithium ion batteries) or 138 (sodium batteries) should also be consulted. If molten aluminum is involved, refer to 169 . (ERG, 2020)

Vapors irritate eyes and nose. Ingestion or skin contact causes headache, nausea, vomiting, dizziness. (USCG, 1999)

ETHYLENE GLYCOL MONOBUTYL ETHER may react with bases, aluminum and oxidizing materials. It is liable to form peroxides on exposure to air and light. It attacks some forms of plastics, rubber and coatings. (NTP, 1992).

• Alcohols and Polyols
• Ethers

Use caution: Liquids with this reactive group classification have been known to react with the absorbent listed below.

• Cellulose-Based Absorbents

Excerpt from 128 [Flammable Liquids (Water-Immiscible)]:

IMMEDIATE PRECAUTIONARY MEASURE: Isolate spill or leak area for at least 50 meters (150 feet) in all directions.

LARGE SPILL: Consider initial downwind evacuation for at least 300 meters (1000 feet).

FIRE: If tank, rail car or tank truck is involved in a fire, ISOLATE for 800 meters (1/2 mile) in all directions; also, consider initial evacuation for 800 meters (1/2 mile) in all directions. (ERG, 2020)

Excerpt from 128 [Flammable Liquids (Water-Immiscible)]:

CAUTION: The majority of these products have a very low flash point. Use of water spray when fighting fire may be inefficient. CAUTION: For mixtures containing alcohol or polar solvent, alcohol-resistant foam may be more effective.

SMALL FIRE: Dry chemical, CO2, water spray or regular foam.

LARGE FIRE: Water spray, fog or regular foam. Avoid aiming straight or solid streams directly onto the product. If it can be done safely, move undamaged containers away from the area around the fire.

FIRE INVOLVING TANKS OR CAR/TRAILER LOADS: Fight fire from maximum distance or use unmanned master stream devices or monitor nozzles. Cool containers with flooding quantities of water until well after fire is out. For petroleum crude oil, do not spray water directly into a breached tank car. This can lead to a dangerous boil over. Withdraw immediately in case of rising sound from venting safety devices or discoloration of tank. ALWAYS stay away from tanks engulfed in fire. For massive fire, use unmanned master stream devices or monitor nozzles; if this is impossible, withdraw from area and let fire burn. (ERG, 2020)

Excerpt from 128 [Flammable Liquids (Water-Immiscible)]:

ELIMINATE all ignition sources (no smoking, flares, sparks or flames) from immediate area. All equipment used when handling the product must be grounded. Do not touch or walk through spilled material. Stop leak if you can do it without risk. Prevent entry into waterways, sewers, basements or confined areas. A vapor-suppressing foam may be used to reduce vapors. Absorb or cover with dry earth, sand or other non-combustible material and transfer to containers. Use clean, non-sparking tools to collect absorbed material.

LARGE SPILL: Dike far ahead of liquid spill for later disposal. Water spray may reduce vapor, but may not prevent ignition in closed spaces. (ERG, 2020)

Excerpt from NIOSH Pocket Guide for 2-Butoxyethanol:

Skin: PREVENT SKIN CONTACT - Wear appropriate personal protective clothing to prevent skin contact.

Eyes: PREVENT EYE CONTACT - Wear appropriate eye protection to prevent eye contact.

Wash skin: WHEN CONTAMINATED - The worker should immediately wash the skin when it becomes contaminated.

Remove: WHEN WET OR CONTAMINATED - Work clothing that becomes wet or significantly contaminated should be removed and replaced.

Change: No recommendation is made specifying the need for the worker to change clothing after the workshift.

Provide: QUICK DRENCH - Facilities for quickly drenching the body should be provided within the immediate work area for emergency use where there is a possibility of exposure. [Note: It is intended that these facilities provide a sufficient quantity or flow of water to quickly remove the substance from any body areas likely to be exposed. The actual determination of what constitutes an adequate quick drench facility depends on the specific circumstances. In certain instances, a deluge shower should be readily available, whereas in others, the availability of water from a sink or hose could be considered adequate.] (NIOSH, 2023)

Normalized Breakthrough Times (in Minutes)

Chemical	CAS Number	State	QS	QC	SL	C3	TF	TP	RC	TK	RF
Butoxy ethanol, 2-	111-76-2	Liquid			>480		>480	>480	>480
Ethylene glycol monobutyl ether	111-76-2	Liquid			>480		>480	>480	>480

Special Warning from DuPont: Tychem® and Tyvek® fabrics should not be used around heat, flames, sparks or in potentially flammable or explosive environments. Only...

(DuPont, 2023)

EYES: First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop.

SKIN: IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. If symptoms such as redness or irritation develop, IMMEDIATELY call a physician and be prepared to transport the victim to a hospital for treatment.

INHALATION: IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used; if not available, use a level of protection greater than or equal to that advised under Protective Clothing.

INGESTION: DO NOT INDUCE VOMITING. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician. If the victim is convulsing or unconscious, do not give anything by mouth, ensure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. IMMEDIATELY transport the victim to a hospital. (NTP, 1992)

• BETA-BUTOXYETHANOL
• BUCS
• 2-BUTOXY-1-ETHANOL
• BUTOXYETHANOL
• 2-BUTOXYETHANOL
• BUTYL CELLOSOLVE
• BUTYL CELLOSOLVE®
• BUTYL CELLU-SOL
• BUTYL GLYCOL
• BUTYL MONOETHER GLYCOL
• BUTYL OXITOL
• C4E1
• CHIMEC NR
• DOWANOL EB
• DOWANOL® EB
• EGBE
• EKTASOLVE EB
• EKTASOLVE EB®
• ETHYLENE GLYCOL BUTYL ETHER
• ETHYLENE GLYCOL MONO-N-BUTYL ETHER
• ETHYLENE GLYCOL MONOBUTYL ETHER
• ETHYLENE GLYCOL N-BUTYL
• ETHYLENE GLYCOL N-BUTYL ETHER
• GAFCOL EB
• GLYCOL BUTYL ETHER
• GLYCOL EB
• GLYCOL ETHER EB
• GLYCOL MONOBUTYL ETHER
• JEFFERSOL EB
• MINEX BDH
• MONOBUTYL ETHER OF ETHYLENE GLYCOL
• MONOBUTYL GLYCOL ETHER
• N-BUTOXYETHANOL
• 2-N-BUTOXYETHANOL
• N-BUTYL CELLOSOLVE
• O-BUTYL ETHYLENE GLYCOL
• 3-OXA-1-HEPTANOL
• POLY-SOLV EB