BROMINE CHLORIDE

A reddish-yellow mobile liquid with an irritating odor. Toxic by ingestion or inhalation, and an irritant to skin, eyes and mucous membranes. Prolonged exposure of the containers to intense heat may result in their violent rupturing and rocketing. Used as an industrial disinfectant.

• Strong Oxidizing Agent
• Water-Reactive

Soluble in water [Hawley]. Reacts with water or steam to produce hydrochloric acid and possibly hydrobromic acid.

Excerpt from ERG Guide 124 [Gases - Toxic and/or Corrosive - Oxidizing]:

Substance does not burn but will support combustion. Vapors from liquefied gas are initially heavier than air and spread along ground. These are strong oxidizers and will react vigorously or explosively with many materials including fuels. May ignite combustibles (wood, paper, oil, clothing, etc.). Some will react violently with air, moist air and/or water. Cylinders exposed to fire may vent and release toxic and/or corrosive gas through pressure relief devices. Containers may explode when heated. Ruptured cylinders may rocket. (ERG, 2016)

Excerpt from ERG Guide 124 [Gases - Toxic and/or Corrosive - Oxidizing]:

TOXIC; may be fatal if inhaled or absorbed through skin. Fire will produce irritating, corrosive and/or toxic gases. Contact with gas or liquefied gas may cause burns, severe injury and/or frostbite. Runoff from fire control may cause pollution. (ERG, 2016)

BROMINE CHLORIDE is a strong oxidizing agent. May react vigorously with combustible materials and generate enough heat to start and support combustion. Decomposes above 50° F to produce highly toxic chlorine gas.

• Oxidizing Agents, Strong
• Halogenating Agents

Use caution: Liquids with this reactive group classification have been known to react with the absorbents listed below.

• Cellulose-Based Absorbents
• Mineral-Based & Clay-Based Absorbents
• Expanded Polymeric Absorbents
• Dirt/Earth

Excerpt from ERG Guide 124 [Gases - Toxic and/or Corrosive - Oxidizing]:

As an immediate precautionary measure, isolate spill or leak area for at least 100 meters (330 feet) in all directions.

SPILL: See ERG Table 1 - Initial Isolation and Protective Action Distances on the UN/NA 2901 datasheet.

FIRE: If tank, rail car or tank truck is involved in a fire, ISOLATE for 800 meters (1/2 mile) in all directions; also, consider initial evacuation for 800 meters (1/2 mile) in all directions. (ERG, 2016)

Excerpt from ERG Guide 124 [Gases - Toxic and/or Corrosive - Oxidizing]:

SMALL FIRE: CAUTION: These materials do not burn but will support combustion. Some will react violently with water. Contain fire and let burn. If fire must be fought, water spray or fog is recommended. Water only; no dry chemical, CO2 or Halon®. Do not get water inside containers. Move containers from fire area if you can do it without risk. Damaged cylinders should be handled only by specialists.

FIRE INVOLVING TANKS: Fight fire from maximum distance or use unmanned hose holders or monitor nozzles. Cool containers with flooding quantities of water until well after fire is out. Do not direct water at source of leak or safety devices; icing may occur. Withdraw immediately in case of rising sound from venting safety devices or discoloration of tank. ALWAYS stay away from tanks engulfed in fire. For massive fire, use unmanned hose holders or monitor nozzles; if this is impossible, withdraw from area and let fire burn. (ERG, 2016)

Excerpt from ERG Guide 124 [Gases - Toxic and/or Corrosive - Oxidizing]:

Fully encapsulating, vapor-protective clothing should be worn for spills and leaks with no fire. Do not touch or walk through spilled material. Keep combustibles (wood, paper, oil, etc.) away from spilled material. Stop leak if you can do it without risk. Use water spray to reduce vapors or divert vapor cloud drift. Avoid allowing water runoff to contact spilled material. Do not direct water at spill or source of leak. If possible, turn leaking containers so that gas escapes rather than liquid. Prevent entry into waterways, sewers, basements or confined areas. Isolate area until gas has dispersed. Ventilate the area. (ERG, 2016)

Excerpt from GUIDE 124 [Gases - Toxic and/or Corrosive - Oxidizing]:

Wear positive pressure self-contained breathing apparatus (SCBA). Wear chemical protective clothing that is specifically recommended by the manufacturer. It may provide little or no thermal protection. Structural firefighters' protective clothing provides limited protection in fire situations ONLY; it is not effective in spill situations where direct contact with the substance is possible. (ERG, 2016)

No information available.

Excerpt from ERG Guide 124 [Gases - Toxic and/or Corrosive - Oxidizing]:

Ensure that medical personnel are aware of the material(s) involved and take precautions to protect themselves. Move victim to fresh air. Call 911 or emergency medical service. Give artificial respiration if victim is not breathing. Do not use mouth-to-mouth method if victim ingested or inhaled the substance; give artificial respiration with the aid of a pocket mask equipped with a one-way valve or other proper respiratory medical device. Administer oxygen if breathing is difficult. Clothing frozen to the skin should be thawed before being removed. Remove and isolate contaminated clothing and shoes. In case of contact with substance, immediately flush skin or eyes with running water for at least 20 minutes. Keep victim calm and warm. Keep victim under observation. Effects of contact or inhalation may be delayed. (ERG, 2016)

• BROMINE CHLORIDE
• BROMINE MONOCHLORIDE
• BROMOCHLORIDE