Print
Chemical Datasheet

ALLYLAMINE

6.1 - Poison Inhalation Hazard 3 - Flammable liquid

Chemical Identifiers

CAS Number UN/NA Number DOT Hazard Label USCG CHRIS Code
  • 107-11-9   (ALLYLAMINE)
  • 2334
  • Poison Inhalation Hazard
  • Flammable Liquid
none
NIOSH Pocket Guide International Chem Safety Card
none
  • ALLYLAMINE
NFPA 704
Diamond Hazard Value Description
3
4 1
Blue Health 4 Can be lethal.
Red Flammability 3 Can be ignited under almost all ambient temperature conditions.
Yellow Instability 1 Normally stable but can become unstable at elevated temperatures and pressures.
White Special
(NFPA, 2010)
General Description
A colorless to light yellow colored liquid with a strong ammonia-like odor. Less dense than water. Vapors are heavier than air. Toxic by inhalation, ingestion and skin absorption. Irritates skin, eyes and mucous membranes. Flash point below 0°F. Boiling point 130°F. Used to make pharmaceuticals and other chemicals.

Hazards

Reactivity Alerts
Air & Water Reactions
Highly flammable. Water soluble.
Fire Hazard
Flammable when exposed to heat, sparks, or flame. Vapor forms explosive mixtures with air over a wide range. Use caution when approaching fire and applying water. Vapor explosion and poison hazard indoors, outdoors or in sewers. Runoff to sewer may create fire or explosion hazard. Can react with oxidizing materials. When heated to decomposition, it emits toxic fumes. Avoid oxidizing materials. Stable, avoid heating to decomposition. May become unstable at elevated temperatures and pressures or may react with water with non-violent release of energy. (EPA, 1998)
Health Hazard
Acute: an eye, skin, and respiratory tract irritant, which is highly toxic if inhaled or ingested and moderately toxic if absorbed on skin. Ingestion or inhalation may cause death or permanent injury after very short exposure to small quantities. Skin absorption may cause irreversible and reversible changes. Toxic air concentration (TClo) in humans is 5 ppm over 5 minutes. Vapors are extremely unpleasant and may ensure voluntary avoidance of dangerous concentrations. Will irritate nose and throat at 2.5 ppm. (EPA, 1998)
Reactivity Profile
ALLYLAMINE reacts violently with strong oxidizing agents and acids. Attacks copper and copper compounds [Handling Chemicals Safely 1980. p. 123]. Reacts with hypochlorites to give N-chloroamines, some of which are explosives when isolated [Bretherick 1979. p. 108].
Belongs to the Following Reactive Group(s)
Potentially Incompatible Absorbents

Use caution: Liquids with this reactive group classification have been known to react with the absorbents listed below.

Response Recommendations

Isolation and Evacuation
Excerpt from 131 Polymerizable warning [Flammable Liquids - Toxic]:

IMMEDIATE PRECAUTIONARY MEASURE: Isolate spill or leak area for at least 50 meters (150 feet) in all directions.

SPILL: See ERG Table 1 - Initial Isolation and Protective Action Distances on the UN/NA 2334 datasheet.

FIRE: If tank, rail car or tank truck is involved in a fire, ISOLATE for 800 meters (1/2 mile) in all directions; also, consider initial evacuation for 800 meters (1/2 mile) in all directions. (ERG, 2020)
Firefighting
Keep unnecessary people away and isolate hazard area. Stay upwind and keep away from low areas. Isolate for 1/2 mile in all directions if tank car or truck is involved. Wear self-contained breathing apparatus and full protective clothing.

Use dry chemical, alcohol foam, or carbon dioxide. Water may be used to keep exposed containers cool. Dike fire control water for later disposal. Withdraw immediately in case of rising sound from venting safety device or discoloration of tank due to fire. (EPA, 1998)
Non-Fire Response
Excerpt from 131 Polymerizable warning [Flammable Liquids - Toxic]:

ELIMINATE all ignition sources (no smoking, flares, sparks or flames) from immediate area. All equipment used when handling the product must be grounded. Do not touch or walk through spilled material. Stop leak if you can do it without risk. Prevent entry into waterways, sewers, basements or confined areas. A vapor-suppressing foam may be used to reduce vapors.

SMALL SPILL: Absorb with earth, sand or other non-combustible material and transfer to containers for later disposal. Use clean, non-sparking tools to collect absorbed material.

LARGE SPILL: Dike far ahead of liquid spill for later disposal. Water spray may reduce vapor, but may not prevent ignition in closed spaces. (ERG, 2020)
Protective Clothing
For emergency situations, wear a positive pressure, pressure-demand, full facepiece self-contained breathing apparatus (SCBA) or pressure- demand supplied air respirator with escape SCBA and a fully-encapsulating, chemical resistant suit. (EPA, 1998)
DuPont Tychem® Suit Fabrics
No information available.
First Aid
Warning: Allylamine is highly irritating. Caution is advised.

Signs and Symptoms of Allylamine Exposure: Signs and symptoms of acute exposure to allylamine may include irritation of nose, eyes, and mouth with tearing, runny nose, cough, and sneezing. Other symptoms include nausea, vomiting, diarrhea, redness, swelling, and pain in mucous membranes. Severe exposure may result in excitability and convulsions.

Emergency Life-Support Procedures: Acute exposure to allylamine may require decontamination and life support for the victims. Emergency personnel should wear protective clothing appropriate to the type and degree of contamination. Air-purifying or supplied-air respiratory equipment should also be worn, as necessary. Rescue vehicles should carry supplies such as plastic sheeting and disposable plastic bags to assist in preventing spread of contamination.

Inhalation Exposure:
1. Move victims to fresh air. Emergency personnel should avoid self-exposure to allylamine.
2. Evaluate vital signs including pulse and respiratory rate and note any trauma. If no pulse is detected, provide CPR. If not breathing, provide artificial respiration. If breathing is labored, administer 100% humidified oxygen or other respiratory support.
3. Obtain authorization and/or further instructions from the local hospital for performance of other invasive procedures.
4. Transport to a health care facility.

Dermal/Eye Exposure:
1. Remove victims from exposure. Emergency personnel should avoid self-exposure to allylamine.
2. Evaluate vital signs including pulse and respiratory rate and note any trauma. If no pulse is detected, provide CPR. If not breathing, provide artificial respiration. If breathing is labored, administer 100% humidified oxygen or other respiratory support.
3. Remove contaminated clothing as soon as possible.
4. If eye exposure has occurred, eyes must be flushed with lukewarm water for at least 15 minutes.
5. Wash exposed skin areas three times with water.
6. Obtain authorization and/or further instructions from the local hospital for administration of an antidote or performance of other invasive procedures.
7. Transport to a health care facility.

Ingestion Exposure:
1. Evaluate vital signs including pulse and respiratory rate and note any trauma. If no pulse is detected, provide CPR. If not breathing, provide artificial respiration. If breathing is labored, administer 100% humidified oxygen or other respiratory support.
2. Obtain authorization and/or further instructions from the local hospital for administration of an antidote or performance of other invasive procedures.
3. DO NOT induce vomiting or attempt to neutralize.
4. Activated charcoal is of no value.
5. Give the victims water or milk: children up to 1 year old, 125 mL (4 oz or 1/2 cup); children 1 to 12 years old, 200 mL (6 oz or 3/4 cup); adults, 250 mL (8 oz or 1 cup). Water or milk should not be given if victims are not conscious and alert.
6. Transport to a health care facility. (EPA, 1998)

Physical Properties

Chemical Formula:
  • C3H7N
Flash Point: -20°F (EPA, 1998)
Lower Explosive Limit (LEL): 2.2 % (EPA, 1998)
Upper Explosive Limit (UEL): 22 % (EPA, 1998)
Autoignition Temperature: 705°F (NTP, 1992)
Melting Point: -126°F (NTP, 1992)
Vapor Pressure: data unavailable
Vapor Density (Relative to Air): 2 (EPA, 1998) - Heavier than air; will sink
Specific Gravity: 0.76 at 68°F (EPA, 1998) - Less dense than water; will float
Boiling Point: 131 to 136°F at 760 mmHg (EPA, 1998)
Molecular Weight: 57.09 (EPA, 1998)
Water Solubility: Very soluble (NTP, 1992)
Ionization Energy/Potential: data unavailable
IDLH: data unavailable

AEGLs (Acute Exposure Guideline Levels)

Final AEGLs for Allyl Amine (107-11-9)
Exposure Period AEGL-1 AEGL-2 AEGL-3
10 minutes 0.42 ppm 3.3 ppm 150 ppm
30 minutes 0.42 ppm 3.3 ppm 40 ppm
60 minutes 0.42 ppm 3.3 ppm 18 ppm
4 hours 0.42 ppm 1.8 ppm 3.5 ppm
8 hours 0.42 ppm 1.2 ppm 2.3 ppm
(NAC/NRC, 2023)

ERPGs (Emergency Response Planning Guidelines)

No ERPG information available.

PACs (Protective Action Criteria)

Chemical PAC-1 PAC-2 PAC-3
Allylamine (107-11-9) 0.42 ppm 3.3 ppm 18 ppm LEL = 22000 ppm
(DOE, 2018)

Regulatory Information

EPA Consolidated List of Lists

Regulatory Name CAS Number/
313 Category Code
EPCRA 302
EHS TPQ
EPCRA 304
EHS RQ
CERCLA RQ EPCRA 313
TRI
RCRA
Code
CAA 112(r)
RMP TQ
2-Propen-1-amine 107-11-9 500 pounds 500 pounds X 10000 pounds
Allylamine 107-11-9 500 pounds 500 pounds 313 10000 pounds

(EPA List of Lists, 2022)

CISA Chemical Facility Anti-Terrorism Standards (CFATS)

RELEASE THEFT SABOTAGE
Chemical of Interest CAS Number Min Conc STQ Security
Issue
Min Conc STQ Security
Issue
Min Conc STQ Security
Issue
Allylamine; [2-Propen-1-amine] 107-11-9 1.00 % 10000 pounds flammable

(CISA, 2007)

OSHA Process Safety Management (PSM) Standard List

Chemical Name CAS Number Threshold Quantity (TQ)
Allylamine 107-11-9 1000 pounds

(OSHA, 2019)

Alternate Chemical Names