ACETONE CYANOHYDRIN, STABILIZED

Diamond	Hazard	Value	Description
2 4 2	Health	4	Can be lethal.
	Flammability	2	Must be moderately heated or exposed to relatively high ambient temperatures before ignition can occur.
	Instability	2	Readily undergoes violent chemical changes at elevated temperatures and pressures.
	Special

A colorless liquid. Flash point 165°F. Lethal by inhalation and highly toxic or lethal by skin absorption. Density 7.8 lb / gal (less dense than water). Vapors heavier than air. Produces toxic oxides of nitrogen during combustion.

• Water-Reactive

Soluble in water. May decompose on contact with water to form acetone and poisonous hydrogen cyanide.

Based on a scenario where the chemical is spilled into an excess of water (at least 5 fold excess of water), half of the maximum theoretical yield of Hydrogen Cyanide gas will be created in 12 minutes. Experimental details are in the following: "Development of the Table of Initial Isolation and Protective Distances for the 2008 Emergency Response Guidebook", ANL/DIS-09-2, D.F. Brown, H.M. Hartmann, W.A. Freeman, and W.D. Haney, Argonne National Laboratory, Argonne, Illinois, June 2009.

Too dangerous to health to expose fire fighters; a few whiffs of vapor could cause death; vapor or liquid could be fatal on penetrating normal protective clothing. Vapor forms explosive mixture with air. Decomposes when heated to 248F or at lower temperature under alkaline conditions, emitting highly toxic hydrogen cyanide. May react violently with water. Contact with sulfuric acid may cause it to explode. (EPA, 1998)

This material is considered very hazardous and should only be handled under conditions that prevent any inhalation of vapor or skin contact. May be slightly irritating to skin and mucous membranes. (EPA, 1998)

ACETONE CYANOHYDRIN readily decomposes to acetone and poisonous hydrogen cyanide gas on contact with water, acids (sulfuric acid) or when exposed to heat. Should be kept cool and slightly acidic (pH 4-5) [Sax, 2nd ed., 1965, p. 388]. Slowly dissociates to acetone, a flammable liquid, and hydrogen cyanide, a flammable poisonous gas, under normal storage and transportation conditions. Rate of dissociation increased by contact with alkalis and/or heat.

• Alcohols and Polyols
• Nitriles

Use caution: Liquids with this reactive group classification have been known to react with the absorbent listed below.

• Cellulose-Based Absorbents

Excerpt from 155 [Substances - Toxic and/or Corrosive (Flammable / Water-Sensitive)]:

IMMEDIATE PRECAUTIONARY MEASURE: Isolate spill or leak area in all directions for at least 50 meters (150 feet) for liquids and at least 25 meters (75 feet) for solids.

SPILL: See ERG Table 1 - Initial Isolation and Protective Action Distances on the UN/NA 1541 datasheet.

FIRE: If tank, rail car or tank truck is involved in a fire, ISOLATE for 800 meters (1/2 mile) in all directions; also, consider initial evacuation for 800 meters (1/2 mile) in all directions. (ERG, 2020)

Wear air-supplied mask with canister approved for use with acrylonitrile in less than 2 percent concentration, rubber or plastic gloves, cover goggles or face mask, rubber boots, slicker suit, safety helmet.

Water may cause frothing if it gets below surface of liquid and turns to steam. Water fog gently applied to surface will cause frothing which will extinguish fire. Use water spray, dry chemical, alcohol foam, or carbon dioxide. Use water to keep fire-exposed containers cool, from a safe distance. (EPA, 1998)

Excerpt from 155 [Substances - Toxic and/or Corrosive (Flammable / Water-Sensitive)]:

ELIMINATE all ignition sources (no smoking, flares, sparks or flames) from immediate area. All equipment used when handling the product must be grounded. Do not touch damaged containers or spilled material unless wearing appropriate protective clothing. Stop leak if you can do it without risk. A vapor-suppressing foam may be used to reduce vapors. FOR CHLOROSILANES, use AFFF alcohol-resistant medium-expansion foam to reduce vapors. DO NOT GET WATER on spilled substance or inside containers. Use water spray to reduce vapors or divert vapor cloud drift. Avoid allowing water runoff to contact spilled material. Prevent entry into waterways, sewers, basements or confined areas.

SMALL SPILL: Cover with DRY earth, DRY sand or other non-combustible material followed with plastic sheet to minimize spreading or contact with rain. Use clean, non-sparking tools to collect material and place it into loosely covered plastic containers for later disposal. (ERG, 2020)

Excerpt from NIOSH Pocket Guide for Acetone cyanohydrin:

Skin: PREVENT SKIN CONTACT - Wear appropriate personal protective clothing to prevent skin contact.

Eyes: PREVENT EYE CONTACT - Wear appropriate eye protection to prevent eye contact.

Wash skin: WHEN CONTAMINATED - The worker should immediately wash the skin when it becomes contaminated.

Remove: WHEN WET OR CONTAMINATED - Work clothing that becomes wet or significantly contaminated should be removed and replaced.

Change: No recommendation is made specifying the need for the worker to change clothing after the workshift.

Provide:
• EYEWASH - Eyewash fountains should be provided in areas where there is any possibility that workers could be exposed to the substances; this is irrespective of the recommendation involving the wearing of eye protection.
• QUICK DRENCH - Facilities for quickly drenching the body should be provided within the immediate work area for emergency use where there is a possibility of exposure. [Note: It is intended that these facilities provide a sufficient quantity or flow of water to quickly remove the substance from any body areas likely to be exposed. The actual determination of what constitutes an adequate quick drench facility depends on the specific circumstances. In certain instances, a deluge shower should be readily available, whereas in others, the availability of water from a sink or hose could be considered adequate.] (NIOSH, 2023)

Normalized Breakthrough Times (in Minutes)

Chemical	CAS Number	State	QS	QC	SL	C3	TF	TP	RC	TK	RF
Acetone cyanohydrin	75-86-5	Liquid					>480	>480	>480	>480	>480
Cyanopropan-2-ol, 2-	75-86-5	Liquid					>480	>480	>480	>480	>480
Hydroxy 2-methylpropionitrile, 2-	75-86-5	Liquid					>480	>480	>480	>480	>480
Hydroxy isobutyronitrile	75-86-5	Liquid					>480	>480	>480	>480	>480

Special Warning from DuPont: Tychem® and Tyvek® fabrics should not be used around heat, flames, sparks or in potentially flammable or explosive environments. Only...

(DuPont, 2023)

Warning: Effects, including skin reactions, may be delayed. Caution is advised. Vital signs should be monitored closely. Heart palpitation may begin within minutes after exposure.

Note: Acetone cyanohydrin is very readily absorbed through the skin.

Signs and Symptoms of Acetone Cyanohydrin Exposure: Signs and symptoms of acute exposure to acetone cyanohydrin may include hypertension (high blood pressure) and tachycardia (rapid heart rate), followed by hypotension (low blood pressure) and bradycardia (slow heart rate). Cherry-red mucous membranes and blood, cardiac arrhythmias, and other cardiac abnormalities are common. Cyanosis (blue tint to the skin and mucous membranes) is not a consistent finding. Tachypnea (rapid respiratory rate) may be followed by respiratory depression. Lung hemorrhage and pulmonary edema may also occur. Headache, vertigo (dizziness), agitation, and giddiness may be followed by combative behavior, convulsions, paralysis, protruding eyeballs, dilated and unreactive pupils, and coma. Acetone cyanohydrin is irritating to the skin and mucous membranes. Lacrimation (tearing) and a burning sensation of the mouth and throat are common. Excessive salivation, nausea, and vomiting may also occur.

Emergency Life-Support Procedures: Acute exposure to acetone cyanohydrin may require decontamination and life support for the victims. Emergency personnel should wear protective clothing appropriate to the type and degree of contamination. Air-purifying or supplied-air respiratory equipment should also be worn, as necessary. Rescue vehicles should carry supplies such as plastic sheeting and disposable plastic bags to assist in preventing spread of contamination.

Inhalation Exposure:
1. Move victims to fresh air. Emergency personnel should avoid self-exposure to acetone cyanohydrin.
2. Evaluate vital signs including pulse and respiratory rate, and note any trauma. If no pulse is detected, provide CPR. If not breathing, provide artificial respiration. IMMEDIATELY begin administering 100% oxygen to all victims. Monitor victims for respiratory distress.Warning: To prevent self-poisoning, avoid mouth-to-mouth breathing; use a forced-oxygen mask. Direct oral contact with acetone cyanohydrin-contaminated persons or their gastric contents may result in self-poisoning.
3. RUSH to a health care facility!
4. Obtain authorization and/or further instructions from the local hospital for administration of an antidote or performance of other invasive procedures.

Dermal/Eye Exposure:
1. Remove victims from exposure. Emergency personnel should avoid self-exposure to acetone cyanohydrin.
2. Evaluate vital signs including pulse and respiratory rate, and note any trauma. If no pulse is detected, provide CPR. If not breathing, provide artificial respiration. IMMEDIATELY begin administering 100% oxygen to all victims. Monitor victims for respiratory distress.Warning: To prevent self-poisoning, avoid mouth-to-mouth breathing; use a forced-oxygen mask. Direct oral contact with acetone cyanohydrin-contaminated persons or their gastric contents may result in self-poisoning.
3. RUSH to a health care facility!
4. Remove contaminated clothing as soon as possible.
5. If eye exposure has occurred, eyes must be flushed with lukewarm water for at least 15 minutes.
6. Wash exposed skin areas twice with soap and water.
7. Obtain authorization and/or further instructions from the local hospital for administration of an antidote or performance of other invasive procedures.

Ingestion Exposure:
1. Evaluate vital signs including pulse and respiratory rate, and note any trauma. If no pulse is detected, provide CPR. If not breathing, provide artificial respiration. IMMEDIATELY begin administering 100% oxygen to all victims. Monitor victims for respiratory distress.Warning: To prevent self-poisoning, avoid mouth-to-mouth breathing; use a forced-oxygen mask. Direct oral contact with acetone cyanohydrin contaminated persons or their gastric contents may result in self-poisoning.
2. RUSH to a health care facility!
3. Obtain authorization and/or further instructions from the local hospital for administration of an antidote or performance of other invasive procedures.
4. DO NOT induce vomiting or attempt to neutralize!
5. Activated charcoal may be administered if victims are conscious and alert. Use 15 to 30 g (1/2 to 1 oz) for children, 50 to 100 g (1-3/4 to 3-1/2 oz) for adults, with 125 to 250 mL (1/2 to 1 cup) of water.
6. Give the victims water or milk: children up to 1 year old, 125 mL (4 oz or 1/2 cup); children 1 to 12 years old, 200 mL (6 oz or 3/4 cup); adults, 250 mL (8 oz or 1 cup). Water or milk should be given only if victims are conscious and alert. (EPA, 1998)

• ACETONE CYANHYDRIN
• ACETONE CYANOHYDRIN
• ACETONE CYANOHYDRIN, STABILIZED
• ALPHA-HYDROXY ISOBUTRONITRILE
• ALPHA-HYDROXYISOBUTYRONITRILE
• 2-CYANO-2-HYDROXYPROPANE
• 2-CYANO-2-PROPANOL
• CYANOHYDRIN-2-PROPANONE
• 2-HYDROXY-2-CYANOPROPANE
• 2-HYDROXY-2-METHYL-PROPIONITRILE
• 2-HYDROXY-2-METHYLPROPANENITRILE
• 2-HYDROXY-2-METHYLPROPIONITRILE
• 2-HYDROXYISOBUTYRONITRILE
• LACTONITRILE, 2-METHYL-
• 2-METHYL-2-HYDROXYPROPIONITRILE
• 2-METHYLACTONITRILE
• 2-METHYLLACTONITRILE
• PROPANENITRILE, 2-HYDROXY-2-METHYL-
• PROPANENITRILE, 2-HYRODXY-2-METHYL
• 2-PROPANONE, CYANOHYDRIN
• USAF RH-8