XYLENESULFONIC ACID, SODIUM SALT

PHYSICAL DESCRIPTION: Odorless white crystalline powder. (NTP, 1992)

none

Water soluble. May be sensitive to moisture.

Flash point data for this chemical are not available; however, it is probably combustible. (NTP, 1992)

SYMPTOMS: Symptoms of exposure to this compound may include irritation of the eyes, nose, throat and skin, blisters, sensitization, coughing and chest discomfort. Redness, soreness, papular dermatitis, thickening of the skin, weeping, cracking and scaling may also occur. Other symptoms may include diarrhea, intestinal distention and, occasionally, vomiting.

ACUTE/CHRONIC HAZARDS: This compound may irritate the nose, eyes, throat and skin. When heated to decomposition it emits toxic fumes of carbon monoxide, carbon dioxide, sulfur oxides and sodium oxides. (NTP, 1992)

XYLENESULFONIC ACID, SODIUM SALT is incompatible with acids and oxidizing materials. (NTP, 1992).

• Salts, Acidic

No information available.

No information available.

Fires involving this material can be controlled with a dry chemical, carbon dioxide or Halon extinguisher. A water spray may also be used. (NTP, 1992)

SMALL SPILLS AND LEAKAGE: If you spill this chemical, you should dampen the solid spill material with water, then transfer the dampened material to a suitable container. Use absorbent paper dampened with water to pick up any remaining material. Seal your contaminated clothing and the absorbent paper in a vapor-tight plastic bag for eventual disposal. Wash all contaminated surfaces with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned.

STORAGE PRECAUTIONS: You should store this chemical under ambient temperatures, and protect it from moisture. If possible, it would be prudent to store this compound under inert atmosphere. (NTP, 1992)

MINIMUM PROTECTIVE CLOTHING: If Tyvek-type disposable protective clothing is not worn during handling of this chemical, wear disposable Tyvek-type sleeves taped to your gloves.

RECOMMENDED RESPIRATOR: Where the neat test chemical is weighed and diluted, wear a NIOSH-approved half face respirator equipped with an organic vapor/acid gas cartridge (specific for organic vapors, HCl, acid gas and SO2) with a dust/mist filter. Splash proof safety goggles should be worn while handling this chemical. Alternatively, a full face respirator, equipped as above, may be used to provide simultaneous eye and respiratory protection. (NTP, 1992)

No information available.

EYES: First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop.

SKIN: IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. IMMEDIATELY call a hospital or poison control center even if no symptoms (such as redness or irritation) develop. IMMEDIATELY transport the victim to a hospital for treatment after washing the affected areas.

INHALATION: IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used; if not available, use a level of protection greater than or equal to that advised under Protective Clothing.

INGESTION: DO NOT INDUCE VOMITING. Corrosive chemicals will destroy the membranes of the mouth, throat, and esophagus and, in addition, have a high risk of being aspirated into the victim's lungs during vomiting which increases the medical problems. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. IMMEDIATELY transport the victim to a hospital. If the victim is convulsing or unconscious, do not give anything by mouth, ensure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. Transport the victim IMMEDIATELY to a hospital. (NTP, 1992)

• ALKATROPE SX-40
• BENZENESULFONIC ACID, DIMETHYL-, SODIUM SALT
• CALSOFT SXS 96
• CARSOSULF SXS
• CONCO SXS
• CYCLOPHIL SXS 30
• CYCLOPHIL SXS30
• DIMETHYLBENZENESULFONIC ACID, SODIUM SALT
• ELTESOL SX 30
• ELTESOL SX93
• HYDROTROPE
• KEMMAT SN 18
• NAXONATE
• NAXONATE 4L
• NAXONATE G
• NAXONATE SX
• NCI-C55403
• REWORYL NXS40
• RICHONATE SXS
• SODIUM DIMETHYLBENZENESULFONATE
• SODIUM XYLENE SULFONATE
• SODIUM XYLENESULFONATE
• STEPANATE SXS
• STEPANATE X
• SURCO SXS
• SXS 40
• ULTRAWET 40SX
• WITCONATE SXS
• XYLENESULFONIC ACID, SODIUM SALT