Print
Chemical Datasheet
CUMYLPHENYLDIPHENYL PHOSPHATE MIXTURE |
|
Chemical Identifiers
| CAS Number |
UN/NA Number |
DOT Hazard Label |
USCG CHRIS Code |
|
none
|
none
|
data unavailable
|
none
|
| NIOSH Pocket Guide |
International Chem Safety Card |
|
none
|
none
|
NFPA 704
data unavailable
General Description
PHYSICAL DESCRIPTION: Clear viscous yellow liquid. (NTP, 1992)
Hazards
Reactivity Alerts
none
Air & Water Reactions
Insoluble in water.
Fire Hazard
This compound is probably combustible. (NTP, 1992)
Health Hazard
No information available.
Reactivity Profile
Organophosphates, such as CUMYLPHENYLDIPHENYL PHOSPHATE, are susceptible to formation of highly toxic and flammable phosphine gas in the presence of strong reducing agents such as hydrides. Partial oxidation by oxidizing agents may result in the release of toxic phosphorus oxides
Belongs to the Following Reactive Group(s)
- Esters, Sulfate Esters, Phosphate Esters, Thiophosphate Esters, and Borate Esters
Potentially Incompatible Absorbents
No information available.
Response Recommendations
Isolation and Evacuation
No information available.
Firefighting
Fires involving this compound should be controlled using a dry chemical, carbon dioxide or Halon extinguisher. (NTP, 1992)
Non-Fire Response
SMALL SPILLS AND LEAKAGE: If you spill this chemical, use absorbent paper to pick up all liquid spill material. Your contaminated clothing and absorbent paper should be sealed in a vapor-tight plastic bag for eventual disposal. Solvent wash all contaminated surfaces with alcohol followed by washing with a strong soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned.
STORAGE PRECAUTIONS: You should store this material in a refrigerator. (NTP, 1992)
Protective Clothing
No information available.
DuPont Tychem® Suit Fabrics
No information available.
First Aid
EYES: Check for contact lenses and remove them at once if present. You should then immediately flush eyes with water from any source for 15 minutes. Do not use oil or ointment in eyes. Arrange immediate transportation to a medical facility.
SKIN: You should remove all contaminated clothing and flood skin with water. Wash all affected skin areas thoroughly with soap and water and seek immediate medical attention.
INHALATION: If any of your personnel should inhale this substance you should remove them immediately to open air. If symptoms develop, seek medical attention.
INGESTION: If the exposed person is convulsing or unconscious, you should not attempt first aid. Transport immediately to a hospital emergency room or poison control center. If the victim is conscious, administer large volumes of liquid then immediately induce vomiting. Transport at once to a medical facility. (NTP, 1992)
Physical Properties
Chemical Formula:
data unavailable
Flash Point:
greater than 200°F
(NTP, 1992)
Lower Explosive Limit (LEL): data unavailable
Upper Explosive Limit (UEL): data unavailable
Autoignition Temperature: data unavailable
Melting Point: data unavailable
Vapor Pressure: data unavailable
Vapor Density (Relative to Air): data unavailable
Specific Gravity: data unavailable
Boiling Point: data unavailable
Molecular Weight: data unavailable
Water Solubility:
less than 1 mg/mL
at 72.5°F
(NTP, 1992)
Ionization Energy/Potential: data unavailable
IDLH: data unavailable
AEGLs (Acute Exposure Guideline Levels)
No AEGL information available.
ERPGs (Emergency Response Planning Guidelines)
No ERPG information available.
PACs (Protective Action Criteria)
No PAC information available.
Regulatory Information
EPA Consolidated List of Lists
No regulatory information available.
CISA Chemical Facility Anti-Terrorism Standards (CFATS)
No regulatory information available.
OSHA Process Safety Management (PSM) Standard List
No regulatory information available.
Alternate Chemical Names
- CUMYLPHENYLDIPHENYL PHOSPHATE MIXTURE
- NCP