Print
Chemical Datasheet
PETROLEUM NAPHTHA, [V.M. & P.] |
|
Chemical Identifiers
CAS Number |
UN/NA Number |
DOT Hazard Label |
USCG CHRIS Code |
|
|
|
|
NIOSH Pocket Guide |
International Chem Safety Card |
VM & P Naphtha
|
none
|
NFPA 704
General Description
Colorless liquid with the odor of gasoline. Less dense than water and insoluble in water. Hence floats on water. Also referred to as Varnish Makers & Painters Naphtha. This petroleum fraction is similar to Petroleum Ether (CAS 8030-30-6) but V.M. & P. is a heavier distillate. Flash point ranges from 20°F to 100°F.
Hazards
Reactivity Alerts
Air & Water Reactions
Highly flammable. Insoluble in water.
Fire Hazard
Excerpt from 128

[Flammable Liquids (Water-Immiscible)]:
HIGHLY FLAMMABLE: Will be easily ignited by heat, sparks or flames. Vapors may form explosive mixtures with air. Vapors may travel to source of ignition and flash back. Most vapors are heavier than air. They will spread along the ground and collect in low or confined areas (sewers, basements, tanks, etc.). Vapor explosion hazard indoors, outdoors or in sewers. Those substances designated with a (P) may polymerize explosively when heated or involved in a fire. Runoff to sewer may create fire or explosion hazard. Containers may explode when heated. Many liquids will float on water. Substance may be transported hot. For hybrid vehicles, 147

(lithium ion batteries) or 138

(sodium batteries) should also be consulted. If molten aluminum is involved, refer to 169

. (ERG, 2020)
Health Hazard
Inhalation of concentrated vapor may cause intoxication. Liquid is not very irritating to skin or eyes but may get into lungs by aspiration. (USCG, 1999)
Reactivity Profile
PETROLEUM NAPHTHA, [V.M. & P.] may be incompatible with strong oxidizing agents like nitric acid. Charring may occur followed by ignition of unreacted material and other nearby combustibles. In other settings, mostly unreactive. Not affected by aqueous solutions of acids, alkalis, most oxidizing agents, and most reducing agents. When heated sufficiently or when ignited in the presence of air, oxygen or strong oxidizing agents, burns exothermically to produce mostly carbon dioxide and water.
Belongs to the Following Reactive Group(s)
- Hydrocarbons, Aromatic
- Hydrocarbons, Aliphatic Saturated
Potentially Incompatible Absorbents
No information available.
Response Recommendations
Isolation and Evacuation
Excerpt from 128

[Flammable Liquids (Water-Immiscible)]:
IMMEDIATE PRECAUTIONARY MEASURE: Isolate spill or leak area for at least 50 meters (150 feet) in all directions.
LARGE SPILL: Consider initial downwind evacuation for at least 300 meters (1000 feet).
FIRE: If tank, rail car or tank truck is involved in a fire, ISOLATE for 800 meters (1/2 mile) in all directions; also, consider initial evacuation for 800 meters (1/2 mile) in all directions. (ERG, 2020)
Firefighting
Fire Extinguishing Agents Not to Be Used: Water may be ineffective.Fire Extinguishing Agents: Foam, carbon dioxide, or dry chemical (USCG, 1999)
Non-Fire Response
Excerpt from 128

[Flammable Liquids (Water-Immiscible)]:
ELIMINATE all ignition sources (no smoking, flares, sparks or flames) from immediate area. All equipment used when handling the product must be grounded. Do not touch or walk through spilled material. Stop leak if you can do it without risk. Prevent entry into waterways, sewers, basements or confined areas. A vapor-suppressing foam may be used to reduce vapors. Absorb or cover with dry earth, sand or other non-combustible material and transfer to containers. Use clean, non-sparking tools to collect absorbed material.
LARGE SPILL: Dike far ahead of liquid spill for later disposal. Water spray may reduce vapor, but may not prevent ignition in closed spaces. (ERG, 2020)
Protective Clothing
Excerpt from NIOSH Pocket Guide for VM & P Naphtha:
Skin: PREVENT SKIN CONTACT - Wear appropriate personal protective clothing to prevent skin contact.
Eyes: PREVENT EYE CONTACT - Wear appropriate eye protection to prevent eye contact.
Wash skin: WHEN CONTAMINATED - The worker should immediately wash the skin when it becomes contaminated.
Remove: WHEN WET (FLAMMABLE) - Work clothing that becomes wet should be immediately removed due to its flammability hazard (i.e., for liquids with a flash point <100°F).
Change: No recommendation is made specifying the need for the worker to change clothing after the workshift. (NIOSH, 2023)
DuPont Tychem® Suit Fabrics
No information available.
First Aid
Excerpt from NIOSH Pocket Guide for VM & P Naphtha:
Eye: IRRIGATE IMMEDIATELY - If this chemical contacts the eyes, immediately wash (irrigate) the eyes with large amounts of water, occasionally lifting the lower and upper lids. Get medical attention immediately.
Skin: SOAP WASH PROMPTLY - If this chemical contacts the skin, promptly wash the contaminated skin with soap and water. If this chemical penetrates the clothing, promptly remove the clothing and wash the skin with soap and water. Get medical attention promptly.
Breathing: RESPIRATORY SUPPORT - If a person breathes large amounts of this chemical, move the exposed person to fresh air at once. If breathing has stopped, perform artificial respiration. Keep the affected person warm and at rest. Get medical attention as soon as possible.
Swallow: MEDICAL ATTENTION IMMEDIATELY - If this chemical has been swallowed, get medical attention immediately. (NIOSH, 2023)
Physical Properties
Chemical Formula:
data unavailable
Flash Point:
20°F
(approx.)
(USCG, 1999)
Lower Explosive Limit (LEL):
0.9 %
(USCG, 1999)
Upper Explosive Limit (UEL):
6 %
(USCG, 1999)
Autoignition Temperature:
450°F
(USCG, 1999)
Melting Point: data unavailable
Vapor Pressure:
2 to 20 mmHg
(NIOSH, 2023)
Vapor Density (Relative to Air): data unavailable
Specific Gravity:
0.74
at 68°F
(USCG, 1999)
- Less dense than water; will float
Boiling Point:
207°F
at 760 mmHg
(USCG, 1999)
Molecular Weight:
87 to 114
(approx)
(NIOSH, 2023)
Water Solubility:
Insoluble
(NIOSH, 2023)
Ionization Energy/Potential: data unavailable
IDLH: data unavailable
AEGLs (Acute Exposure Guideline Levels)
No AEGL information available.
ERPGs (Emergency Response Planning Guidelines)
No ERPG information available.
PACs (Protective Action Criteria)
Chemical |
PAC-1 |
PAC-2 |
PAC-3 |
Petroleum distillates; petroleum ether; includes clay-treated light naphthenic [64742-45-6]; low boiling [68477-31-6]; petroleum extracts [64742-06-9]; petroleum base oil [64742-46-7]; petroleum 50 thinner, petroleum spirits [64475-85-0], Soltrol, VM&P naphtha [8032-32-4]; Ligroine, and paint solvent; petroleum paraffins C5-C20 [64771-72-8]; hydrotreated light naphthenic [64742-53-6]; solvent refined light naphthenic [64741-97-5]; and machine coolant 1
|
1100 mg/m3 |
1800 mg/m3 |
40000 mg/m3 |
(DOE, 2018)
Regulatory Information
EPA Consolidated List of Lists
No regulatory information available.
CISA Chemical Facility Anti-Terrorism Standards (CFATS)
No regulatory information available.
OSHA Process Safety Management (PSM) Standard List
No regulatory information available.
Alternate Chemical Names
- HIGH SOLVENT NAPHTHA
- NAPHTHA
- PETROLEUM NAPHTHA
- PETROLEUM NAPHTHA, [FLAMMABLE LIQUID LABEL]
- PETROLEUM NAPHTHA, [V.M. & P.]
- PETROLEUM NAPHTHA, [VARNISH MAKERS & PAINTERS]
- V,M&P NAPHTHA, [WOOD PRESERVATIVE]
- VM & P NAPHTHA