Print
Chemical Datasheet

CORN OIL

1
0 0
 

Chemical Identifiers

UN/NA Number CAS Number CHRIS Code DOT Hazard Label
none
  • 8001-30-7
none data unavailable
NFPA 704:
  • Red 1 -- Flammability: Must be preheated to burn
  • Blue 0 -- Health Hazard: Like ordinary material
  • Yellow 0 -- Reactivity: Normally stable
General Description
PHYSICAL DESCRIPTION: Clear light yellow or yellow oily liquid. Faint taste. Faint odor. (NTP, 1992)

Hazards

Reactivity Alerts
none
Air & Water Reactions
Insoluble in water.
Fire Hazard
This chemical is combustible. (NTP, 1992)
Health Hazard
SYMPTOMS: Symptoms of exposure to this compound may include skin irritation. This compound may be an allergen.

ACUTE/CHRONIC HAZARDS: When heated to decomposition this compound may emit toxic and hazardous fumes. (NTP, 1992)
Reactivity Profile
On prolonged exposure to air, CORN OIL thickens and becomes rancid. It is sensitive to light.
Belongs to the Following Reactive Group(s)

Response Recommendations

Firefighting
Fires involving this material can be controlled with a dry chemical, carbon dioxide or Halon extinguisher. (NTP, 1992)
Non-Fire Response
SMALL SPILLS AND LEAKAGE: If you should spill this chemical, FIRST REMOVE ALL SOURCES OF IGNITION, then use absorbent paper to pick up all liquid spill material. Your contaminated clothing and absorbent paper should be sealed in a vapor-tight plastic bag for eventual disposal. Solvent wash all contaminated surfaces with acetone followed by washing with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned.

STORAGE PRECAUTIONS: You should protect this material from exposure to light, and store it in a refrigerator. (NTP, 1992)
Protective Clothing
RECOMMENDED RESPIRATOR: Where the neat test chemical is weighed and diluted, wear a NIOSH-approved half face respirator equipped with an organic vapor/acid gas cartridge (specific for organic vapors, HCl, acid gas and SO2) with a dust/mist filter. (NTP, 1992)
First Aid
EYES: First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop.

SKIN: IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. If symptoms such as redness or irritation develop, IMMEDIATELY call a physician and be prepared to transport the victim to a hospital for treatment.

INHALATION: IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used; if not available, use a level of protection greater than or equal to that advised under Protective Clothing.

INGESTION: DO NOT INDUCE VOMITING. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician. If the victim is convulsing or unconscious, do not give anything by mouth, ensure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. IMMEDIATELY transport the victim to a hospital. (NTP, 1992)

Physical Properties

Molecular Formula: data unavailable
Flash Point: 490.0 ° F (NTP, 1992)
Lower Explosive Limit: data unavailable
Upper Explosive Limit: data unavailable
Autoignition Temperature: 740.0 ° F (NTP, 1992)
Melting Point: 0-14 ° F (NTP, 1992)
Vapor Pressure: data unavailable
Vapor Density: data unavailable
Specific Gravity: 0.916-0.921 at 77.0 ° F (NTP, 1992)
Boiling Point: data unavailable
Molecular Weight: data unavailable
Water Solubility: <1 mg/mL at 64° F (NTP, 1992)
AEGL: data unavailable
ERPG: data unavailable
TEEL-1 TEEL-2 TEEL-3
500.0 mg/m3 500.0 mg/m3 500.0 mg/m3
(SCAPA, 2008)
IDLH: data unavailable

Regulatory Information

Regulatory Names: none
CAA RMP: Not a regulated chemical.
CERCLA: Not a regulated chemical.
EHS (EPCRA 302): Not a regulated chemical.
TRI (EPCRA 313): Not a regulated chemical.
RCRA Chemical Code: none

Alternate Chemical Names